Phoenix Metro
TV Mounting & Installation in Phoenix.
- (480) 771-3252
- Serving the entire Phoenix metro — we come to you
- Office: Mon–Fri 8:00 AM – 5:00 PM · 24/7 emergency service
- 2-year workmanship warranty · 1-year parts warranty
- Veteran-owned & operated · residential + commercial
- 73 five-star Google reviews
From the couch, a mounted TV is a clean rectangle on the wall. From inside the wall, it is two engineering questions: whether the anchoring can genuinely carry that load on that wall type, and whether the power got there legally. The second one surprises people, because the most common way TVs get cleaned up, dropping the power cord into the wall cavity, violates the electrical code outright.
We mount TVs as a licensed electrical contractor, which means the cords disappear the lawful way: a recessed outlet behind the screen on a properly extended circuit, in-wall rated signal cable, and anchoring matched to Phoenix construction, wood studs and block masonry alike. This page covers how we do it, what drives the quote, and where the honest DIY line sits.
What this work involves
Every mount job is the same five questions: what is the wall, what is the TV, where is the power, where is the signal, and what does the room need. The power question is where being an electrical contractor matters. Television power cords, like all appliance cords, are not rated or permitted to run inside wall cavities. The code-compliant answer is to put an outlet where the TV is: a recessed receptacle behind the screen, fed by lawfully extending the circuit, so the factory cord plugs in out of sight without ever entering the wall.
Answering the wall question first matters just as much. We locate framing or confirm masonry, sweep the cavity path for plumbing, wiring, and ducts, and only then commit to mounting positions and hardware. Surprises belong in the assessment, not halfway through a drilled hole.
Here is the anatomy of the visit:
Stud layout or masonry, what is inside the cavity, plumbing, wiring, ducts, and whether a fireplace below changes the thermal picture.
Fixed, tilt, or full-motion matched to the room, with weight ratings verified against the actual television rather than assumed.
A recessed outlet behind the screen on a properly extended circuit. No cords inside walls, no extension-cord tricks, nothing an inspector or an insurance adjuster would frown at.
In-wall rated HDMI and data cable between the TV and the equipment location, with conduit or raceway offered where future-proofing makes sense.
Lag bolts into framing on stud walls; rated masonry anchors set into the block itself on masonry walls. Hardware selected for the load, not whatever came in the box.
Level confirmed, hardware torqued, cables dressed, and every source verified working before we call it done.
TV Mounting & Installation pricing in Phoenix
Written flat-rate pricing after we see the wall, because the wall is the job. Two identical TVs can be very different installs: one on a frame wall with power nearby, one on a block wall a room away from the nearest receptacle. Diagnostic fees, where they apply, are disclosed on the phone before booking, and the quote states the permit call in writing. If you have not bought the TV or the mount yet, ask us first; a quick conversation about wall type and room often saves buying hardware twice.
| Cost factor | What it changes |
|---|---|
| Wall construction | Frame walls take standard fastening and fishing. Block and masonry walls need drilling, rated anchors, and routing decisions. |
| Power relocation scope | How far the circuit must lawfully extend to feed the recessed outlet behind the screen drives the electrical share of the job. |
| TV size and mount class | Larger screens and full-motion mounts mean heavier hardware, more careful anchoring, and usually a second set of hands. |
| Accessory wiring | Soundbars, consoles, and streamers add signal runs, and conduit for future cable swaps adds material but saves the next project. |
| Location | Interior living room, above a fireplace, or out on a patio each carry their own hardware and weather considerations. |
The Arizona-specific part
Phoenix construction puts more TVs on masonry than most markets. Block exterior and party walls run all through Valley housing stock, and hanging a big screen on block is entirely doable, but it is hardware work: anchors rated for masonry, set into the solid block rather than the mortar joints, drilled cleanly with the dust controlled. What block will not forgive is drywall-anchor optimism. The other structural surprise is the fireplace niche common in Valley tract homes, often finished in stone veneer over a firebox that changes the heat picture. We treat those on their merits: mantel heat checked with the fireplace running, tilt or pull-down hardware where height demands it, and an honest recommendation when a different wall would serve the room better.
Patios are the Arizona bonus round. Outdoor living is most of the year here, and a patio TV earns its place, but the desert taxes it: west sun creates glare and cooks panels, monsoon dust settles on everything, and rain arrives sideways when it arrives at all. So patio installs get planned around shade and viewing angle first, then weather-rated recessed power behind an in-use cover, then a frank conversation about outdoor-rated televisions versus a standard set in a genuinely sheltered corner. Full-motion arms on patios get one extra habit: fold them flat against the wall when a storm rolls through.
Interior placement has a Phoenix wrinkle of its own: glare. Big west-facing windows are standard in Valley great rooms, and an afternoon sun angle can wash out a perfectly mounted screen. Part of our walkthrough is standing where you sit at the times you actually watch, because the right wall in the morning can be the wrong wall late in the day, and a tilt or full-motion mount is sometimes the whole fix.
How we run the job
We look at the wall, the TV, and your equipment plan, then hand you a flat-rate written quote. The permit call is stated in writing: the mounting itself is not permit work, but lawfully extending a circuit for the recessed outlet can be, depending on your city, and we make that call for your address rather than leaving it vague.
On install day, floors and furniture get protected and drilling is done with dust control, which matters double on block. The mount goes up, the power goes in, the cables get dressed, and then we prove the system: every input, the soundbar, the streaming sources, all working before we pack up. Any access openings and their patching are stated in the scope up front, so the finished wall is part of the plan rather than an afterthought. The work carries our 2-year written workmanship warranty, and the 10% military, veteran, and first-responder discount applies here like it does across our electrical work. We mount across the whole metro, and the contact page gets you on the schedule.
TV Mounting & Installation FAQs
Can you hide all the cords in the wall legally?
Yes, that is the core of the service. The lawful architecture is a recessed outlet behind the screen, fed by a properly extended circuit, plus in-wall rated signal cables running down to your equipment. The TV’s own power cord plugs in behind the panel and never enters the wall cavity. Everything visible disappears; nothing illegal happens. It also keeps you clean with insurance and with the next home inspector, who absolutely will notice a cord buried in drywall.
Can a big TV mount on a block wall?
Yes. Masonry is a strong substrate when the anchoring is right: anchors rated for the load, set into the solid block rather than the mortar joints, drilled cleanly. What fails on block walls is improvised hardware. We size the anchors to the mount and the television, including the seventy-five-inch class panels people are buying now.
What about a TV on the patio?
A great idea when it is planned correctly: placement out of direct west sun for glare and panel life, weather-rated power behind an in-use cover, and either an outdoor-rated television or a genuinely sheltered spot with honest expectations. Monsoon dust means occasional cleaning, and storm nights are a good time to fold a full-motion arm flat.
Why is running the TV power cord inside the wall against code?
Appliance cords are not rated for installation inside building cavities; they are built for open air, and buried in a wall they become a heat and damage risk the code explicitly prohibits. The rule has a constructive flip side: it is why the recessed-outlet-behind-the-TV method exists, which is safer and looks cleaner anyway.
Can you mount a TV over a fireplace?
Often, carefully. We check the wall temperature with the fireplace actually running, because some niches run hotter than any television tolerates well, and we talk honestly about height and neck angle. Tilt and pull-down mounts solve a lot of it. When a fireplace wall is a poor home for the screen, we say so and point to the better wall. Stone and veneer surfaces get drilled with the right bits and finished cleanly where hardware lands.
What happens to the old outlet down by the media stand?
It stays and keeps working. We extend the circuit up to the new recessed outlet rather than moving anything, so your console equipment, lamps, and vacuum still have power below while the television feeds from behind the screen above. You end up with two useful outlets instead of one relocated one. If the existing outlet turns out to sit on an overloaded circuit, we tell you before extending it.
Fixed, tilt, or full-motion: which mount should I get?
Fixed sits thinnest against the wall and suits eye-level installs viewed head-on. Tilt corrects for screens mounted higher than ideal, over consoles or fireplaces. Full-motion earns its place in corner placements, rooms with multiple seating areas, and patios. Wall type and TV weight narrow the field, and we bring the judgment. Share the room dimensions when you call and we can narrow the choice before the visit.
Can you wire in a soundbar and hide its cable too?
Yes. The soundbar’s power comes from the same lawful recessed-outlet approach, and its signal runs in-wall on rated cable alongside the TV feed. If you are the type to upgrade gear, conduit behind the wall makes every future cable swap trivial instead of a drywall project, and we suggest it while the wall is already open.
How high should a TV be mounted?
Lower than most people guess. The comfortable rule is the center of the screen near seated eye level for a room watched head-on, nudged higher only when furniture or a fireplace forces it, with tilt making up the difference. We mark the height with you and stand back to check it before any holes are drilled. Households disagree about this step more than any other, which is why the tape-and-stand-back moment happens before the drill comes out.
Permits and inspections
Most repairs are ordinary service work; bigger scopes can involve city permitting. We perform our work to code, pull the permits our scope requires, and put what we did in writing.
What's covered
Workmanship is covered for two full years, in writing, and repair parts carry a 1-year manufacturer parts warranty — we document installs and repairs so those claims stay simple to make
Why a licensed electrical contractor matters.
Phoenix metro: Most days a tech is already working somewhere in the Valley, so same-day appointments happen when the schedule allows. After-hours emergencies are dispatched when a licensed tech is available — a real person answers and tells you the ETA on the call.
Call (480) 771-3252Request an estimate.
No pressure, no door knockers. We look at the electrical, tell you what it needs (and what it doesn’t), and put the number in writing.